Hydron NSF 100 GPD Membrane

HYDRON RESIDENTIAL/ LIGHT COMMERCIAL MEMBRANES Are a reliable alternative for your residential/light commercial and small system membrane needs. HYDRON Membranes are amanufacturedin a State-of-the-art, ISO-9001-2000 certified automatic rolling facility, providing you with a precise and advanced membrane element that not only delivers an attractive cost to benefit ratio, but also gives you a membrane that has consisitently of high quality and performance. Can be used in a variety of small size system applications such as household water purification, laboratory, hydroponics, hospital, and many other applications where a reliable, performace membrane is needed. MEMBRANE TYPE Polyamide Compound TESTING CONDITIONS Testing Pressure 60 psi (0.41 MPa) (4.1 bar) Temperature of Testing Solution 77 °F (25 °C) Concentration of Testing Solution (NaCl) 250 ppm pH Value of Testing Solution 7.5 Recovery Rate of Single Membrane Element 15% EXTREME OPERATION CONDITIONS Max. Working Pressure 300 psi (2.07 MPa) (20.7 bar) Max/ Feedwater Temperature 113 °F (45 °C) Max. Feedwater SDI 5 Single Membrane Max. Pressure Drop 10 psi (0.07 MPa) (0.7 bar) Residual Chlorine Concentration of Feedwater <0.1 ppm pH Range of Feedwater during Continuous Operation 3~10 pH Range of Feedwater during Chemical Cleaning 2~12 Max. Temperature for Continuous Operation above pH 10 95 °F (35°C) IMPORTANT INFORMATION Under certain conditions, the presence of free chlorine and other oxidizing agents will cause the premature membrane failure. Since oxidation damage is not covered under warranty, HYDRON recommends removing residual free chlorine by pretreatment prior to membrane exposure. Any specific application must be limited within the extreme operating conditions. We strongly recommend you to refer to the latest edition of technology manual and deign guide prepared by HYDRON Membrane Technology of consult experts proficient in membrane technology. In case the customer fails to follow the operating conditions as specified in this manual, HYDRON Membrane Technology will assume no liability for all results. The permeate flow listed in the table is the average value. The permeate flow of single membrane element is within a tolerance not exceeding +/- 20% of nominal value. Discard the RO-filtered water produced during the first one hour after system start-up. During storage time and run time, it is strictly prohibited to dose any chemical medicament that may be harmful.